Mobile:+91-9650823988,180030701098
Mail Us:activeindiahelpline@gmail.com

Dual Band 900-1800 Mhz. Mobile Signal Booster

2G Mobile Signal Booster
buy-now

PRICE:-17,000/- FREE CASH ON DELIVERY AVAILABLE

About Signal Booster Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save a life. Unfortunately, there are still some places where one can find themselves - out of coverage. Usually those places are either too far from the cell phone base station or located inside underground constructions, for example: parking lots, tunnels, big stores, office buildings, cars, boats, house in remote areas, etc.
Here we will bring you a new kind of LED signal booster. Welcome to buy!

Features

  • High-gain linear power amplifier.
  • ALC and AGC function technology.
  • Ultra-low noise receive amplifier.
  • There is no interference to the base station, right after the opening of the original system and the base station without the need to adjust parameters.
  • Stable and reliable electromagnetic compatibility design.
  • The base station dose not cause an increase in background noise, but will not lead to a decline in the quality of the base station communications.
  • With full-duplex communication mode.
  • It explores an effective and reasonable method to dispel the heat.

 Model No

GSM-DCS-Yellow

Parameter data

Uplink

Downlink

Frequency Range

890-915 Mhz.
1710-1785MHz 

935-960 MHZ

1805-1880MHz

Output Power 

20 ±2dBm

20 ±2dBm

Gain

65 dB

65dB

Bandwidth

Wide Band

Automatic Gain Control

>20dB

Ripple in Band

≤5dB

Intermodulation Products

9KHz~1GHz

≤ -36 dBm

1GHz~12.75GHz

≤ -30 dBm

Spurious Emission

9KHz~1GHz

≤ -36 dBm

1GHz~12.75GHz

≤ -30 dBm

Noise Figure @ max. gain

≤ 6 dB

VSWR

≤2

MTBF

>50000 hours

Power Supply

AC:90~265V, 50/ 60Hz;DC:12V 2A

Power Consumption

< 20W

Impedance

50 ohm

Mechanical Specification

RF Connector

N-Female

Cooling

Heatsink Convection cooling

Dimensions (D x W xH )

198*182*20 mm

Weight

1.2kg

Installation Type

Wall Installation

Environment Conditions

IP40

Humidity

< 90%

Operating Temperature

-10°C ~ 55°C

 

Installation Steps

1. Use your mobile phone to test signal strength outside house or on roof, -70dBm is the basic requirement (full bar). 
2. Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal. 
3. Run outdoor coaxial cable into building in a convenient location to connect with signal repeater. 
4. Mount your indoor antenna with signal repeater. 
5. Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.